Cable Tie Manufacturing Equipment
The equipments is the key factor for the success molding, which is explaining one by one in detail in the article.
The equipment is the key factor for the success molding. In this article, we have listed all the necessary equipment for the cable tie manufacturing, including cable tie injection molding machine, cable tie mold, and the auxiliary machine. There are brief introductions for each one, please read the following passages:
Attention: besides the equipment, raw materials operation is the part needs to be noted .
The relation and principle please check the cable tie manufacturing, which will help you to better undestand this article
1. Cable Tie Injection Molding Machine
In the oversea market, K288F and K358F are always the first choices for clients. Their stability is approved by time. Sometime one or two of these two model machine may already make you king in your area. Cable tie injection molding machine is the frame for the cable tie manufacturing, which should be determined firstly.
K650L and K850L machines are big machine, specially for the hot runner mold.
Characters of the cable tie injection molding machine:
– Optimize clamping unit specially for cable tie mold, which is thin and long. So that the machine may carry the challenge of high pressure impact under each clamping. Assure the long life of the machine.
– Optimize barrel and screw according to the PA66’s character, solved the problem of PA66 feeding and moisture remove, providing huge plasticizing ability.
– Upgrade power system to assure the huge output under short cycle time.
An machine optimized specially for cable tie manufacturing will obtain the stable and huge productive output at once.
More specification about the machine will be sent on receipt of request email.
# K288F and K358F requests cool runner mold, breve specification:
# K650L and K850L are the huge machines, special for the hot runner mold.
2. Cable Tie Mold
Cable tie mold of cool runner.
The cavities of molds must correspond with the machine, otherwise it will lead to many problems.
More detail, please check this article: cable tie mold, information for cable tie mold design drawing, mold manufacturing, attention points etc.
Cable tie size: 2.5 x 100, 140 cavities
Cable tie size: 4.8 x 400, 24 cavities
3. Auxiliary Machines for Cable Tie Manufacturing
3.1 Hopper Dryer
PA66 absorbs moisture. The plastic resin needs to be dried before production. (click the picture for more information)
3.2 Auto Loader
Load resin to the hopper once monitor that the hopper is empty.
Reduce the worker’s job, such as load by hand and monitor resin quantity in hopper.
Ensure the continuity of production
Mix the resin（PA66, PA6 etc） according to our formula.
Crush the runner.
3.5 Mold Temperature Controller
Warm up the mold temperature to assure the successful molding.
3.6 Packing Machine
Vocuum, Water Injection and Seal in one station reducing the worker’s job and worker’s number
Avoid the application of steam equipment, which is too large and low-efficient.
3.7 Unload Robot
Meet the requirement of high-speed cycle time of 24 hours.
Stable and safe for workers.
Stable output guarantee.