The Basis For Setting The Cooling Time In Injection Molding In injection production, the cooling time of plastic injection molding parts accounts for about 80%
The Reasons for Robot Failure
The cause of robot failure
The connecting part of the robot is mainly fixed by screws. So it may be loosened due to long-term vibration, causing the failure of robot or some connecting parts to break.
On the other hand, robot vibration may cause the wire connector or relay to loosen, resulting in poor circuit contact. Then, the robot may be out of control, the electronic control system stop and the electronic control is burned.
Pay attention to daily protection
1.Shock absorber: Replace regularly
2.The cylinders that have been used for a long time, so we should replace the air pipes, and the seals of the joints in time.
3.Regularly check the wire connectors, plugs, and sockets.
4.Pneumatic components: All simple or multi-functional robots rely on the supply of air sources, which requires a stable source of air and no water. Air and water are different media, gases are invisible while water is visible. Solenoid valves are precision components. When water stays in the electromagnetic, air pipe or cylinder, scale will be generated. And it may cause the solenoid valve to be stuck, gas release, seal damage, air leakage inside and outside the cylinder, unstable or no movement, air pipe and connection. Damage, etc.
In summary, the automatic robot can effectively replace the manual operation. It can also improve the production efficiency of the enterprise. Besides, the maintenance cost is low. Of course, robots also need carefully maintaining during routine maintenance to avoid failures and impact on productivity.
Now, do you know how to avoid the failure of robot ?