Machine Features and Functions

Clamp Unit

1. Electric Door

required for large machine

2. Copper Tube Lubrication


3. Blowing

When increasing the amount of blowing, you need to ensure that the controller program also increases accordingly.

             4. Core Pulling

When adding core pulling, you need to ensure that the controller program also increases accordingly.

             5. Increase the ejection force


  • How to change the ejection cylinder
  • How thimble is distributed
  • The need to strengthen the thimble plate

             6. Mold Opening

  • The mold opening stroke increases
  • Add more corinth column to the thread

Injection Unit

1. Special srew barrel

Features of Special screw barrel:

  • Wear-resistant bimetallic screw, bimetallic barrel
  • Electroplating screw-PC, etc. for materials with high viscosity

2. A and C Crew

  • A screw, small diameter, increased pressure, low plasticizing speed
  • C screw, large diameter, reduced pressure, high plasticizing speed

3. Material tube group is not installed

(1) Whether the length of the material tube group is the same as the original one from factory, otherwise the foot of the carriage needs to be adjusted.

In the case of shortening the material tube group:

  • Move the carriage and its feet forward, or add the carriage feet in front (two sets). After moving forward, the carriage rods and other supporting equipment need to be reconfigured.
  • Increase the length of the nozzle and the barrel flange with the prerequisite of not affecting the product molding. If you increase the length of the nozzle, you need to consider the new

(2) For the size of the heating winding and the installation of the thermocouple, you need to check the models of the heating winding personally, because there are many errors in the warehouse delivery.

             4. Independent CNC back pressure

         The controller program needs to be updated accordingly


             5. Infrared heating winding



1. Protection Project

  • Front door mechanical protection
  • Front door electronic protection
  • Front door hydraulic protection
  • Backdoor protection project

2. Appearance of Machine

  • Which kind of LOGO
  • Which machine nameplate
  • Which sign of machine model

3. Frame Unit

Attention :

(1) The color  and the height of frame

(2) Whether the hopper is needed


4. Electric Box

Sheet metal color and design

  • Solid state relay
  • The temperature access points of the controller, 9118 and 9110 have different number of access points
  • Whether the voltage is 380V,  220V in some countries
  • If the power regulator is needed

5. Number of fast water transport interface


6. Manipulator interface, Euro 12 or 64


7. Power System

Attention :

(1) Oil pump and motor

(2)Hydraulic motor (or oil motor, sol motor)


8. Three-color alarm light


9. Other Matters


  • Hydraulic oil temperature detection
  • Four corner pull ring
  • Carriage centralized lubrication
  • Hydraulic oil temperature monitoring, computer can display the value
  • Hydraulic oil level detection

Leave a Comment

Contact Us