Technical Requirements for Mold Venting In the manufacturing of molds, proper mold venting is a crucial aspect. Mold venting can represent the overall quality of

Classification of Molds 1. Various Classifications of Molds 1.1 Classified by Hardness: Soft Mold, Hard Mold (Quenching Treatment) 1.2 Classified by Quality Grade: Grade 1,

How to Modify Mold Cavity Dimensions? If the produced product dimensions deviate, it means there is an issue with the mold cavity dimensions. Once the

3. Design Dimensions for Venting Channels The Mold Cavity Venting Methods The thinner the wall of the product, and the farther it is from the

What Are Necessary for Injection Mold Design? 1. Design Basis (1) Dimensional accuracy and correctness of relevant dimensions The determination of the external quality and

Product Issues and Solutions During Injection Mold Testing 1. Main Runner Adhesion ① Polish the main runner  →  ② Align the nozzle with the mold center 

How to Improve the Life of Injection Mold? Mold life has always been an important factor affecting the profitability of injection molding projects. If the

Polishing Treatment for Plastic Molds With the widespread application of plastic products, such as daily-use items and beverage packaging containers, there is often a requirement

Assessment Regulations for Mold Trial Exceeding 3 Times Assessment Regulations for Mold Trial 1. Purpose The purpose of this regulation is to standardize the work of

About Rubber Molds Common Types of Rubber Molds In the manufacturing of rubber molds, some commonly used mold types include: 1. Open Molds Open molds

When and How Should Injection Molds Be Modified? When the surface quality of plastic parts fails to meet the design requirements due to weld lines,

Standard Injection Mold Development Process Guide on the Injection Mold Development In general, the standard injection mold development process includes the following 4 steps: Mold

Application Analysis of Hot Runner System What is a hot runner system? The hot runner system is a key element of a multi-cavity injection mold.

The Reasons for Mold Failure and Scrap Reasons for mold failure and scrap In the actual injection molding production site, there are five main reasons for

The Analysis of Injection Mold Failure Injection mold failure and solution The structure and processing quality of the injection mold directly affect the quality and

Guide for Injection Mold Design About the Injection Mold Design There are many important factors that will affect the design of injection mold. Therefore, we

Points That Need to Be Confirmed When Using Steel for Injection Molds There are 6 points that need to be checked when using steel in

Management of Injection Mold Mold management can be roughly divided into 3 different parts.  That is mold development, mold use and mold maintenance.  Therefore, for the effective

Injection Mold Maintenance What are included in injection mold maintenance？ As the most important production tool of the injection molding factory, the injection molding mold

The Design of Main Runner in Injection Mold The use of the main runner design In the mold design process of plastic injection molding, it is necessary to

The Reasons of the Demoulding Difficulty of Plastic Injection Mold After the plastic part is injection molded, the plastic part is ejected from the mold

Why Should the Injection Mold Be Equipped with An Exhaust System ? The exhaust of injection mold is an important issue in mold design.  Especially

Analysis and Countermeasures of Poor Gate Cutting Poor gate cutting It refers to a phenomenon in which the gate connecting the molded product, the main runner,

Advantages of Using Small Gates for Injection Molding Introduction of the Small Gate The gate is a critical section of the material flow channel in

Key Points for New Mold Test About new mold test 1. Test steps A. Before testing the mold, check whether the mold is assembled and whether