The Reasons for Robot Failure The cause of robot failure The connecting part of the robot is mainly fixed by screws. So it may be loosened due to long-term vibration, causing the failure of robot or some connecting parts to break. On the other hand, robot vibration may cause the wire connector or relay to loosen, resulting … Read more

Injection Molding Cost Keeps HIGH? 8 Ways to Reduce Your Injection Molding Cost Ways to reduce thr injection molding cost This post gives you some advice on reducing the injection molding cost from 8 aspects. 1. Production workshop   The layout of production workshop focuses on two aspects: meeting the production requirements, optimizing the layout … Read more

The Barrel Temperature Control of Injection Molding Machine Barrel temperature control 1. Controlled by Microcomputer The temperature of injection molding machine barrel is controlled by the microcomputer control loop. Select the appropriate algorithm to control the heating band outside the barrel of the injection machine. Ensure that the working temperature of each section of the … Read more